Tag Archives: automotive standards

JASO M101 Metal Pipes for Automobile Tubing

1. Scope This standard specifies the metal pipes for tubing mainly used for brakes, fuel and lubrication of automobiles (hereinafter referred to as the “pipes”). Remarks: The applicable standards for this standards are shown below. JIS G3141 Cold rolled carbon steel sheets and strip JIS G3445 Carbon steel tubes for machine structural purposes JIS G […]

Standards

SAE J1677 Tests and Procedures for Carbon Steel and Low Alloy Steel Tubing

1. SCOPE This SAE Standard is intended to establish uniform methods for testing certain types of carbon steel and alloy steel tubing listed in 2.1.1. The specified test and performance criteria applicable to each variety of tubing are set forth in the respective SAE J Specifications. 2. REFERENCES 2.1 Applicable Publications The following publications form […]

Standards

GM123M GM124M Automotive Steel Tubing For Fluid Handling

1 Scope These specifications cover two types of steel tubing suitable for automotive uses. There are requirements for the base metal, the optional coating materials, and the coated tubing. These requirements are applicable to the product coming out of the tube mills and the coating application lines, which are sometimes separate facilities. This tubing is […]

Standards

Indian Standard – IS8119 SPECIFICATION FOR COPPER BRAZED STEEL TUBING

0. FOREWORD 0.1 This Indian Standard was adopted by the Indian Standards Institution on 15 July 1976, after the draft finalized by the Steel Tubes, Pipes and Fittings Sectional Committee had been approved by the Structural and Metals Division Council. 0.2 There has been a long felt need for copper brazed steel tubes used specially in […]

Standards

SAE J527 Brazed Double Wall Low-Carbon Steel Tubing

1. Scope—This SAE Standard covers brazed double wall low-carbon steel tubing intended for general automotive, refrigeration, hydraulic, and other similar applications requiring tubing of a suitable quality for bending, flaring, beading, forming, and brazing. 2. References 2.1 Applicable Publications—The following publications form a part of this specification to the extent specified herein. Unless otherwise specified, the […]

Standards